Engine oil VALVOLINE or AMSOIL

Originally switched to Amsoil for the Noack rating but stayed because it's just good stuff. I now run Amsoil products for all fluids in all vehicles.

Might I suggest Valvoline Restore and Protect. It is magic in a bottle and it's anti wear package is off the charts with oil analysis.

Had een Corsa van 2008 met ketting. Deze begon al vrij snel olie te drinken (liter per 3000km).

Toen kreeg ik het advies om deze olie te kopen van een vriend, daar heb ik probleemloos nog 7 jaar mee gereden.

I noticed that the engine was way smoother (way less vibration) when lightly lugging the gears at 1600 - 1800 rpm on the Valvoline vs the stock oil or Castrol Magnatec. The Valvoline did the same on my 2022 BRZ vs the stock oil and the dealership bulk Magnatec. I also tried Shell oil and the Valvoline is by far the smoothest below 2000 rpm. Almost no oil burnt or evaporated in between oil changes on both cars (less than 100ml per 3k miles) with the Valvoline Advanced.

I use AMSOIL 5W-30 for both of our vehicles. Never had any issues on either vehicle using AMSOIL.

Prima spul. Jarenlang gebruikt voor mijn getz.

Amsoil Signature 5w-20 + K&N Gold oil filter (HP1017 for 4th gens, not sure about 5th) is arguably the single best combo if you can afford the oil. Your lobes will thank you.

Valvoline.. niets mis mee, doe het in mn A4 B6 en Golf 4 Gti... Draait er echt niet minder om... Ook van de action.

NOW, my last oil change I did 2 weeks ago I used Valvoline Restore & Protect after using various Mobil1 & Valvoline high mileage oils. And so far after checking my dipstick today the oil level is still at the top of the fill line. I’m not guaranteeing that this oil is in fact revolutionary but I have noticed significant loss in oil consumption & a more quiet engine bay.

I have run the 5w-40 and stuff every day here in utah and it works fine on 300-400 bhp setups. If you are going to the strip or the dyno and going for probably 450-500 crank I would probably grab that gold top mobil one 15w-50. I would also use that for any road racing where the engine oil gets really thinned out from heat. It's also cheap at wal mart I believe. Over at 575-600 bhp we lost a main bearing when doing endurance testing on valve springs with the 5w-40 and very reasonable oil temps. It didn't really catastrophically fail, but was on it's way to it when we tore it down. Have since switched to VR1 20w-50, and the problem so far appears to be cured. That stuff will carry way more load then the thinner oils- the catch is that it's absolute sludge until warmed up. Yet another one of the barriers to extreme power "street" cars I suppose. I'm keeping an eye on it to see if we have a solution. If that doesn't fix it, the problem may be aeration of the oil- we were running at 7500+ for pretty long periods. So basically now the oiling system is a major focus of R&D for us. The oil pressure was never out of the ordinary- although it does start falling once past about 7500 rpms which is also not great.