Yes this is proper. If deleted don’t worry too much about the 507, i believe 505 will still work. Afaik the euro spec for Pennzoil is about the ash levels. I usually put in liquimoly 4200, but i was an awful amout low between changes when i checked last so I got 5 litres of this for 40 bucks canadian which was a steal. Topped it off and no problems.
I use Liqui Molly - which has the Volvo-required spec - purchased through FCP Euro. Hope that helps.
In my A4 2.0T I use 4qts of Liqui Moly 5w40 and 1qt of Lucas Heavy Duty Oil Treatment.
Liquimoly is only oil you should be running in your turbo vw
For best performance use liqui moly 5w30. I have also used it recently in my japanese alto with above 100K km.
For [Naturally-Aspirated Skyactiv engines](https://en.wikipedia.org/wiki/SkyActiv), it is highly recommended that you use Mazda's own(Idemitsu) high molly GF-5 0w-20. [Arguably it is one of the best oil for skyactiv engines](http://www.cleanmpg.com/community/index.php?threads/45295/#post-357910).
I have a 14 Passat. I do full synthetic LiquiMoly with the VW spec. I change it out every 6-6500 miles.
Liquimoly leichtlauf 5w40. Been told it’s a bit better than 5w30 in a 20+ year old engine due to being a bit thicker. Also does better at higher temps and I drive like a dick
Liqui Moly leichtlauf hightech 5w40. Because it matches the BMW LL-01 specification and was formulated to help with the sticky piston rings issue common to many german engines. Noticed lower oil temp under load and a gradual reduction of oil consumption
The most notable change between the Gen1 and Gen 2 is viscosity. It is much thinner than old oil. few of my customers have already noticed higher oil consumption compared to old formulation. Liqui Moly has done the same. They have reformulated their popular Leichtlauf 5W40 to much lower viscosity. @ 100C it is almost as thin as 5W30.
Write your review
Help others - share your experience with this part.
