Engine oil AMSOIL or Mannol

amsoil is so much better

VW recommends 505.01 for fixed service at 15k Km or 507.00 for flexible service at 30k Km. Since our driving condition is harsh, I usually cut those Km in half. Since you were pushing 505.01 at 12k I would recommend you use 507.00 5W30 LongLife for 15k to 18k to be on the safe zone especially if your runs are on highways. I’d highly recommend you check oil from Mannol 507.00, I’ve been using them and they are solid choice. It costs under 3.5k for 5L. You can fill 4.4L at change of oil and top up 200ml at 4,8 and 12k interval

I like using Amsoil because its very good at withstanding heat.

The dreaded Pentastar tick is GONE! It took about a week of regular use for the noise (on the passenger side of the top of the engine) that used to show up after idling for a few minutes to completely disappear with the new oil. I’m sure plenty of oils work fine but I went with Amsoil because my brother gave me a gift card and referral coupon for my birthday. I run 6 qts because I already have the Baxter spin-on adapter. Which requires a little more oil. The dipstick reads “low” at 5 qts whether I’m idling or checking it after the Jeep has been off for ten minutes. With 6 qts it sits right and holds a steady 30 PSI and never spikes. Such a relief!

Amsoil Signature 5W20

I use AMSOIL engine oil and coolant in mine for the 5 years and have no issues in that department.

Using Amsoil. Nung pinalitan ko valve gasket ng 2008 Vios ko walang sludge. Gold ang loob.

I have use Amsoil European since new! 185,540km so far, and still purrs like a kitten, does not use oil, and the oil is highly rated!

Ik heb Mannol (Energy nogwat...) gebruikt, motor werd iets stiller maar verbruikte meer olie. Kan ook aan wat anders liggen, aangezien het een 18 jaar oude auto is. Bij de laatste beurt zag ik natte bougies en witte aanslag.

Absolutely Liqumoly!

Please never put Amsoil in a Volkswagen they under rate their viscosity/ wt ratings and the only time I used their oil I ended up spinning a rod bearing in my first R32