Brake pads Zimmermann or OEM Mazda

I did them 6 months ago. I used import direct rotors from o Reilly. and some brake pads from NAPA I think I used Zimmerman brake pads. I have 0 problems with them and only need to do my rears in a couple of months according to the wear sensor.

Brake pads and OEM tyres lasted more than 100 000 Km.

My 12 of this generation is at 222k miles with just oil changes and tires as well. One set of pads and rotors at 175k and still had life left.

Zimmerman blank rotors are a good street replacement. No need to pay for drilled/slotted rotors. Personally I went with ceramic brake pads. They don’t bite quite as hard as metallic, but they still bite well, don’t make as much brake dust, and they don’t seize to my rotors after they get wet

I love all things zimmermann brakes. Not the cheapest but some of the highest quality in my opinion.

I inherited a 2011 cx7 from my parents who purchased this car new. They have always kept care of their vehicles. This is a non turbo model. Other than normal maintenance items they had replaced the AC compressor. Since I took it over in 2020, I replaced drive side front wheel bearing and passenger front caliper, brake pads all the way around plus normal maintenance items. 320,000km runs perfectly.

Changed the pads front and rear was super easy and straight forward.Then after taking the car out of 'electric brake service mode' and starting the car I get the a yellow check engine light and code C05AB, clearing it made no difference. Only thing I could find online was "The electronically controlled brake unit detects that the pressure feed valve (primary side) is stuck ON (OPEN)."

i remember hearing a guy complain about his cx5 eating through brakes, but the cx5 is the same car as my mazda3, and my mazda3 has seen 70,000km for its rear brake pad/ 90,000km for the fronts, and I drive a mix of city/highway.

I put OEM Brakes on my ‘19 3 GT AWD. I’m 20K KM into them, and they pulse like mad when I brake above 90KM/h. Absolute fucking trash. The factory brakes also did this, above 90KM, but started around 50K into their life.

Mazda brakes are notoriously shit. They’re garbage. Buy a set of PowerStop brakes and be done with it. They’re far superior to the Mazda brakes. Go on any forum and you’ll see countless people having the same issue as you. New brakes between 15-20,000 miles. Me included. I’ve owned 2 6s from new. Both needed brakes around 20,000 miles. Both times I put on PowerStops and never had another issue.