Brake pads TRW or WILWOOD

I got the ceramic TRW pads from FCP euro. You can find them from ShopDAP, VW dealership, etc. There’s multiple OE suppliers that all work great: TRW, Pagid, Textar. You can also go for the semi metallic equivalent if you want a little extra bite. I believe they all come with the wear sensor, you can simply cut it off at the base and pull out the wire. I’ve done this twice now, no problems. I suppose you could use the advance auto ones if you already have them, but just know they probably won’t give you as much bite as the stock pads, and may end up causing some warping over time since they aren’t designed for the heat temps.

Job got done in about three evenings Biggest time sinks were figuring out how to use the caliper piston compression tool and getting my overtorqued/rusted lug nuts off. Drove up from Maryland to NYC with no problems so I think I did the job right.

I have the TRW TPC1633 ceramic pads installed, perfect fit (OEM) and brake as good as stock...actually smoother. Dust is reduced maybe by half.

TRW Ceramic pads, look identical to OEM, since TRW makes the OEM pads. Feel same as stock, way down on dust.

Finally got around to getting my brakes installed. I've barely put 10 miles on the setup, and the improvement is quite noticeable. Initial bite is improved, and much less effort is required for the same braking force.

In an effort of "lets start over with the basics" we changed the front pads with new TRW OEM ones and the thing was back to normal awesome braking. This Van should stop with alacrity and ABS should kick in when you really step on the brakes.

Here's mine. MMP adapter brackets, stock 11" rotors, BP20 pads. Work very well.

I've got them on my SLC as well. They are amazing. I have stainless hoses and drilled/slotted rotors all around. Went from stock brakes with mintex red box pads, to Girling 60's with hawk hps pads, and put Wilwoods on it last year and the wilwood's just blow the others out of the water. AND they fit under the stock wheels.

I have run Wilwoods on my Corrado for years with the usual rebuilding every two years. Even with ABS under full braking using the BP10 pads it would occasionally lock up fully and blow a cogged belt off the supercharger.

I don't know much about Stop-Tech, however, I have heard from a friend that used Wilwood that these perform best in non-Winter driving conditions. He said that over time they will not stand up as well as a Brembo set up. It might be worth noting what climate (Alaska vs California) that you spend most of your driving time in as well when factoring a BBK upgrade. I also noticed that you are quite new to this group so allow me to introduce you to the member who will derail all original posts into something else to the point where your thread may get locked up. See below. GoGo Golf R said: Ok let's try to agree on the following: 1) Upgrading the brakes is mostly justified for track driving purposes No, Personal preference. 2) Changing the brake pads will reduce dust for street driving Depends on your pad choice 3) Changing the brake pads, rotors and brake lines is pricy Subjective 4) The OEM brakes, while not totally ideal for every driving style, will suffice for average street drivers and some track drivers Depends on your driving style 5) Downshifting with correct rev-matching, will extend the duration and reduce wear on the brakes Yes because replacing your clutch is much cheaper than new pads :screwy: