Brake pads STOPTECH or OEM Chevrolet

Grimmspeed MCB, STOPTECH Sport package (pads, rotors, lines) and the GR86 Shock/Strut retrofit.

I mean I hit 90k miles before I needed pads on a chevy colorado so...

I have a 13 year old Chevy Volt with 173,000 miles still on its original brakes.

I have stoptech "performance brake pads" on my front and rear. Feels like OEM but more dusty

It's a solid pedal feel.

To me it looks like brake pad material on your rotors due to your street pads melting. Slap a new set a cheap pads on there from Autozone or something and drive it for a week or two that material should come off. As long as you don’t have vibration while braking they should still be good. Just make sure to use track pads next time. I personally run StopTech 309 pads because they’re good on track and street

My Equinox has 10,400km and will always make noise under braking at the beginning of the ride and then gradually stops. Braking feels good though.

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

Chevrolet. One of the issues the car had was when it would rain. The brakes wouldn't always work.

My 2025 RS AWD has been having squealing brakes since 1,000 miles at low speed. It has 3,500 on it now and it's annoying.