Brake pads Raybestos or OEM Chevrolet

I like them. Used them for 2 years and have a lot of backroads and a couple of track sessions on them. The shims that come with them rattle a lot.

I recently replaced my factory Kia front pads with some EHT's. Did not replace rotors, just cleaned and removed some rust on them. Applied some caliper grease to the proper areas and these pads so far have been really nice. A VERY noticeable difference vs. the factory pads in stopping power. My only complaint was that Raybestos did not include new pad retainer springs in the box.

Guy above says don’t go cheap….I just used some raybestos pads and rotors for the rear I got from rock auto for 100$. Cheap, fast and easy. First time doing brakes and despite some snags had it done in an hour.

Fitted my 2017 with new front/rear brakes and rotors yesterday. I went with the daily driver level Raybestos brand kit from Rockauto. Included both pads and rotors with hardware. Did the work myself. While I obviously can't say anything about longevity yet, performance seems good so far. Especially for the price when compared to over double for Duralast from my local AutoZone.

I've had great results from Raybestos ST43s and Ferodo DS2500s for dual duty.

I'm using raybestos SP436ATRH for the pads and raybestos 96632FZN for the rotors. Been using them since January and have put about 6k on them, living in a really hilly area with my drums being basically useless because the shoes have been coated in gear oil due to an axle leak. I javent had any issues with brake fade or warping and I took them on a 2hr trip to west virginia from central ohio in March.

I use these pads (and rotors) on my FX35. A couple things I have noticed:

1). There have never been appropriate rattle clips included with any set of pads that I have ever purchased for this car…ever. I am still on OEM stuff at 180k miles. That isn’t just Raybestos. I even ordered Centric hardware…no dice. Not even close. Mind you, I always order model-specific hardware. No idea what the issue is, but it is clearly for the wrong car.

2). These pads take a few stops to heat up, which I kind of expected. I am satisfied with them on my daily, but the rotors are another matter entirely. They all warp within a month or two. That is odd considering they advertise the construction as Dura-Bar. That should be pretty resistant to that kind of thing. They definitely don’t hold up like Centrics do.

3). The shims have a nasty habit of falling off. Not while driving, but during service. You have one maybe two removals before they go MIA.

Other than that, I am not sure that I have noticed an issue with the pads being either wrong or out of tolerance. That is very not what I would expect from a brand like this.

I had to replace my Bolt's pads because of using the friction brakes so little due to one-pedal driving, they rusted out. It's actually important to make a point of using your friction brakes every now and then.

Back in September 2024, I bought two Chevy Equinox EV 2025s — one for me and one for my wife. Both vehicles have less than 10,000 miles on them. And guess what? Both are already having the exact same issue: the brakes make a horrible squealing noise every time you press the pedal, and when you go in reverse the sound is absolutely unbearable.

I’ve taken both SUVs to the dealer twice already. Each time I had to pay $35 for a brake inspection, and both times they told me “everything was fine.” Now, on the third visit, they suddenly tell me the brake pads need to be replaced, and it’s going to cost $498 PER VEHICLE. That’s nearly $1,000 out of my pocket for what I strongly believe is a manufacturing defect.

Here’s what frustrates me the most:

• Both vehicles are covered under the extended warranty, but the dealer says brakes are “not included.”

• They claim the warranty only covers the battery and motors.

• How is it possible that two brand-new vehicles, same model, same mileage, bought at the same time, have the same brake problem, and it’s NOT considered a factory defect?

This makes zero sense. Honestly, I feel scammed. I trusted Chevy, bought two brand-new EVs, and in less than a year they’re already trying to squeeze almost a grand out of me for something that should not be happening.

First post in evo forum, looking for any advice on how to lower the noise from my raybestos ST-43 brake pads. I know that these are race pads, and I take the car to the track, but lately I've had to drive it to work as well. During city driving, when I brake from like 20mph, the screech is so loud its starting to become painful to my ears. I am trying my best now to just do sudden stops. They don't make much noise if I press the brake pedal firmly.