Brake pads Raybestos or JURID

I replaced my rear pads with Raybestos EHT1761 at 23,000 miles. I did not replace the rotors as they were undamaged. I did buy rear rotors, Powerstop EBR1697EVC. I am at 37,000 now with no dust, no noise, and minimal pad wear.

On rockauto, Raybestos sells the element 3 rotor and brake and rotor kit. Basically all I use for my brake changes now. Great stopping power, and pads last a good while also. Highly recomend Raybestos element 3.

For aftermarket pads, Raybestos have had very good fitment and quality, I dig it. Their product line is called like "el3ment" or some such.

Buy pads and the sensor from FCP Euro. Use their lifetime replacement warranty for the next set. Went to the dealer in July for an alignment and they recommended pads for a similar price. I bought pads rotors and sensors for front and back, total was $1000 for BMW parts. You could save with Jurid which is listed as OE and OEM. My pads are at 4mm all around so I'm actually waiting for the sensor to trip before doing the job.

I would go with the Raybestos Element 3 kit sold here. $180 total roughly front and back. 2 seperate kits, one for front, one for back. You will find this under the fully coated section here as they have different grades of pads. For the price and how long these last, you cannot beat it. And better than the top quality parts local parts stores carry, in fact Napa sells these rebranded as their premium top of the line brakes and rotors. For the price, and the quality, is by far your best option. There are better pads that will last a little longer, but are much more pricey. With the miles you drive, these will last 5-10 years. I use these on all vehicles in the rust belt, as these are rust coated.

I bought Raybestos Element 3 Hybrid pads and couldn't be happier. They squeal a tiny bit when very cold but I trust these brakes to get me down a mountain.

If you're keeping the vehicle (make sure you're keeping it), then I second getting the raybestos from Rockauto. Make sure you get the raybestos element 3 fully coated rotor and pad sets.

Even if your friend's dad does it free, maybe drop him $100 or $200 for the labor.

So $200 total. And less dust than OEM with decent stopping power. I went with this combo cause it's balanced stopping power and rotor longevity.

I just put on Raybestos R-line pads and rotors on a 2010 Town and Country. Those vans are notorious squealers. The trick is to use the spray version of disc brake quiet.

The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.

Just replaced rear brakes on my ‘15 rogue with Raybestos E3 pads. I really had to force the pad into the new hardware clips. I did a quick google search and his seems to be an issue with E3 brake hardware. The original brake pads were also really tough to remove before I put the new ones in.