Brake pads Raybestos or ENDLESS

Endless MX72+. Low dust and good bite as long as you don't overheat them.

I really liked my Endless MX72 on the road.

on my old brz with PP Brembos i really liked the endless super street type S pads. there are even better pads by endless depending on your application, like the MX series someone else mentioned.  I only dailied my car and did a couple hard backroads drives a month maybe. but it felt great any time, and even more when the pads were up to temp.

My favorite is still the endless mx72/mx72plus, not the most aggressive pad out there but they warm up extremely quick and for street cars the added bonus of surprisingly small amount of brake dust

I like them. Used them for 2 years and have a lot of backroads and a couple of track sessions on them. The shims that come with them rattle a lot.

I recently replaced my factory Kia front pads with some EHT's. Did not replace rotors, just cleaned and removed some rust on them. Applied some caliper grease to the proper areas and these pads so far have been really nice. A VERY noticeable difference vs. the factory pads in stopping power. My only complaint was that Raybestos did not include new pad retainer springs in the box.

Guy above says don’t go cheap….I just used some raybestos pads and rotors for the rear I got from rock auto for 100$. Cheap, fast and easy. First time doing brakes and despite some snags had it done in an hour.

Fitted my 2017 with new front/rear brakes and rotors yesterday. I went with the daily driver level Raybestos brand kit from Rockauto. Included both pads and rotors with hardware. Did the work myself. While I obviously can't say anything about longevity yet, performance seems good so far. Especially for the price when compared to over double for Duralast from my local AutoZone.

I use these pads (and rotors) on my FX35. A couple things I have noticed:

1). There have never been appropriate rattle clips included with any set of pads that I have ever purchased for this car…ever. I am still on OEM stuff at 180k miles. That isn’t just Raybestos. I even ordered Centric hardware…no dice. Not even close. Mind you, I always order model-specific hardware. No idea what the issue is, but it is clearly for the wrong car.

2). These pads take a few stops to heat up, which I kind of expected. I am satisfied with them on my daily, but the rotors are another matter entirely. They all warp within a month or two. That is odd considering they advertise the construction as Dura-Bar. That should be pretty resistant to that kind of thing. They definitely don’t hold up like Centrics do.

3). The shims have a nasty habit of falling off. Not while driving, but during service. You have one maybe two removals before they go MIA.

Other than that, I am not sure that I have noticed an issue with the pads being either wrong or out of tolerance. That is very not what I would expect from a brand like this.

I installed these less than a year ago on my 4runner. At first, I thought the squealing was going to go away after I broke them in. But almost a year later and they squeal really loud even if I brake slowly at low speeds.