Brake pads Raybestos or Bendix

I've had great results from Raybestos ST43s and Ferodo DS2500s for dual duty.

I'm using raybestos SP436ATRH for the pads and raybestos 96632FZN for the rotors. Been using them since January and have put about 6k on them, living in a really hilly area with my drums being basically useless because the shoes have been coated in gear oil due to an axle leak. I javent had any issues with brake fade or warping and I took them on a 2hr trip to west virginia from central ohio in March.

I replaced my rear pads with Raybestos EHT1761 at 23,000 miles. I did not replace the rotors as they were undamaged. I did buy rear rotors, Powerstop EBR1697EVC. I am at 37,000 now with no dust, no noise, and minimal pad wear.

On rockauto, Raybestos sells the element 3 rotor and brake and rotor kit. Basically all I use for my brake changes now. Great stopping power, and pads last a good while also. Highly recomend Raybestos element 3.

For aftermarket pads, Raybestos have had very good fitment and quality, I dig it. Their product line is called like "el3ment" or some such.

I would go with the Raybestos Element 3 kit sold here. $180 total roughly front and back. 2 seperate kits, one for front, one for back. You will find this under the fully coated section here as they have different grades of pads. For the price and how long these last, you cannot beat it. And better than the top quality parts local parts stores carry, in fact Napa sells these rebranded as their premium top of the line brakes and rotors. For the price, and the quality, is by far your best option. There are better pads that will last a little longer, but are much more pricey. With the miles you drive, these will last 5-10 years. I use these on all vehicles in the rust belt, as these are rust coated.

I bought Raybestos Element 3 Hybrid pads and couldn't be happier. They squeal a tiny bit when very cold but I trust these brakes to get me down a mountain.

I use these pads (and rotors) on my FX35. A couple things I have noticed:

1). There have never been appropriate rattle clips included with any set of pads that I have ever purchased for this car…ever. I am still on OEM stuff at 180k miles. That isn’t just Raybestos. I even ordered Centric hardware…no dice. Not even close. Mind you, I always order model-specific hardware. No idea what the issue is, but it is clearly for the wrong car.

2). These pads take a few stops to heat up, which I kind of expected. I am satisfied with them on my daily, but the rotors are another matter entirely. They all warp within a month or two. That is odd considering they advertise the construction as Dura-Bar. That should be pretty resistant to that kind of thing. They definitely don’t hold up like Centrics do.

3). The shims have a nasty habit of falling off. Not while driving, but during service. You have one maybe two removals before they go MIA.

Other than that, I am not sure that I have noticed an issue with the pads being either wrong or out of tolerance. That is very not what I would expect from a brand like this.

Those Bendix Brake Pads have been almost doubled in price over store bought.

I installed these less than a year ago on my 4runner. At first, I thought the squealing was going to go away after I broke them in. But almost a year later and they squeal really loud even if I brake slowly at low speeds.