Brake pads R1 Concepts or OEM FORD

Rotors were getting rusted decided to have them replaced with R1 Concepts Brake pads and Drilled/Slotted rotors. They perform a little better than the OEM with a quicker breaking point.

Had this on our Ford Kuga £860. Did it myself although I already have all the tools for £280 all round.

Got them on. Lasted for a good amount. 20k miles. Weekend track slowing from 160mph+ don’t use ceramic pads something softer would be better

I have R1 on now all around and no issues since.

changed my OG set at 120k currently just under 140k.

I have a 2016 ST3, 114k miles, OEM brakes at 6mm or so, I mostly do highway.

Running the R1 concept with ceramic pads now and have no issues. They bite a lot better then the stock setup I had on it before.

New rotors and pads without breaking in at all, just normal driving as soon as changed. Pads lasted 30.000km ish, while rotors wrapped at about 40.000km ish (pads replaced at 30k with same R1 concepts). Brake feel and performance was OK, but much worse than when broken in. Light squeal at about 15.000km and onwards. New rotors and pads following break in procedure, 10 stops from 90km/h (55mph aprox), never coming to a complete stop, then driving 30 minutes never coming to a complete stop, rolling to a stop on neutral and waiting another 30 minutes. Pads lasted about 40.000km ish, rotors lasted 80.000km ish, pads replaced at 40.000km with same R1 concepts ceramic.

After two years or so I get horrible squealing when I stop in reverse. Rusting is pretty bad too.

The more I drive it the more and more the brakes squeak horribly. The brakes look fine and it stops on a dime, but man the squeaking is so loud and embarrassing. The car is just so new at only 5,000 miles to already have issues really disappointed me. Especially on how expensive they are and already has issues.