Brake pads Project Mu or WILWOOD

I really liked Project Mu Club Racers as a "streetable-ish" track pad. They were fairly tolerable on the street as long as they were bedded in. They occasionally squeal when coming to a stop once below 15mph.

Higher-temp and higher-mu pads (Project Mu HC+R3) + braided brake lines + DOT 4 fluid for me. Slotted fronts, blank rears.

Red stuff are absolutely NOT track worthy. Will fade in like 1 lap. Any pads advertised as "low dust" tend to fade pretty fast. Yellow might be ok but I think they're still more of a performance street pad. Project MU HC+ are a good streetable track pad, maybe the best, use them on my Megane RS, no trouble with 20 mins sessions on high speed tracks and trackday tyres (Yokohama AD09). A little squeel at low speed on track but quiet enough to live with IMO.

Project MU HC+ pads. These have a higher operating temp range than Ferodo DS2500 and are perfectly streetable too. I get very minor squeal when coming to a stop if it's been a while since they were used hard. they also have great braking feel IMO, nice and sharp, and perfectly controllable. I use them on a Renault Megane RS 280 Cup, I've used them on track with semi-slicks (AD09s) and they held up great in 15 min sessions. Some minor vibration after the day but that fades away with use (or another hard besdding session). Do not recommend Ferodo DS2500 especially with semi slicks. Might be ok for your first day if you're slow, but you'll almost certainly cook them on your second and get deposits on your rotors. Great performance pads or the street though. On my car I only use them on the front, rears are stock.

I did Project MU B force pads. DBA 4000 rotors, Stop tech stainless steel brake lines, Motul 660 brake fluid, radium brake booster brace(a must). Make sure to set those pads in the correct sequence and they gonna rip your face off bud! I had 6 piston brembos also, what a difference!

I do not recommend these for the street, however the track performance is off the charts.

They’re track/race pads, but I rarely track my car. It’s not a daily, just a fun weekend car, but I find the pad performance to be amazing and they’re not noisy like everyone says they would be.

However, the biggest difference I've noticed was going from good brake pads to great ones. I recommend anything by Project Mu (I use their RC09 "Club Racer")

I have run Wilwoods on my Corrado for years with the usual rebuilding every two years. Even with ABS under full braking using the BP10 pads it would occasionally lock up fully and blow a cogged belt off the supercharger.

I don't know much about Stop-Tech, however, I have heard from a friend that used Wilwood that these perform best in non-Winter driving conditions. He said that over time they will not stand up as well as a Brembo set up. It might be worth noting what climate (Alaska vs California) that you spend most of your driving time in as well when factoring a BBK upgrade. I also noticed that you are quite new to this group so allow me to introduce you to the member who will derail all original posts into something else to the point where your thread may get locked up. See below. GoGo Golf R said: Ok let's try to agree on the following: 1) Upgrading the brakes is mostly justified for track driving purposes No, Personal preference. 2) Changing the brake pads will reduce dust for street driving Depends on your pad choice 3) Changing the brake pads, rotors and brake lines is pricy Subjective 4) The OEM brakes, while not totally ideal for every driving style, will suffice for average street drivers and some track drivers Depends on your driving style 5) Downshifting with correct rev-matching, will extend the duration and reduce wear on the brakes Yes because replacing your clutch is much cheaper than new pads :screwy: