Brake pads Project Mu or OEM KIA

I have a 2015 Kia Soul I bought new. In over 9 years, not a single thing has gone wrong with it - no repairs of any kind. Just oil, brakes and tires.

Red stuff are absolutely NOT track worthy. Will fade in like 1 lap. Any pads advertised as "low dust" tend to fade pretty fast. Yellow might be ok but I think they're still more of a performance street pad. Project MU HC+ are a good streetable track pad, maybe the best, use them on my Megane RS, no trouble with 20 mins sessions on high speed tracks and trackday tyres (Yokohama AD09). A little squeel at low speed on track but quiet enough to live with IMO.

Project MU HC+ pads. These have a higher operating temp range than Ferodo DS2500 and are perfectly streetable too. I get very minor squeal when coming to a stop if it's been a while since they were used hard. they also have great braking feel IMO, nice and sharp, and perfectly controllable. I use them on a Renault Megane RS 280 Cup, I've used them on track with semi-slicks (AD09s) and they held up great in 15 min sessions. Some minor vibration after the day but that fades away with use (or another hard besdding session). Do not recommend Ferodo DS2500 especially with semi slicks. Might be ok for your first day if you're slow, but you'll almost certainly cook them on your second and get deposits on your rotors. Great performance pads or the street though. On my car I only use them on the front, rears are stock.

I did Project MU B force pads. DBA 4000 rotors, Stop tech stainless steel brake lines, Motul 660 brake fluid, radium brake booster brace(a must). Make sure to set those pads in the correct sequence and they gonna rip your face off bud! I had 6 piston brembos also, what a difference!

I do not recommend these for the street, however the track performance is off the charts.

They’re track/race pads, but I rarely track my car. It’s not a daily, just a fun weekend car, but I find the pad performance to be amazing and they’re not noisy like everyone says they would be.

However, the biggest difference I've noticed was going from good brake pads to great ones. I recommend anything by Project Mu (I use their RC09 "Club Racer")

The rotors/brake pads are notoriously bad. The oem pads leave uneven deposits on the rotor. Causes shaking while braking. Ive replaced rotors twice. Got better pads and drilled and slotted rotors. No issues since.

I found Project Mu Club Racers to be decently streetable for a track pad. They do squeal a bit at less than 25 but are tolerable as long as they’re bedded in and you’re giving a decent amount of threshold pressure.

Factory tires are garbage, but good all seasons and it gets around in the snow fairly well. My rear brake pad that had little wear, fell apart while driving in the mountains around the same time ( not covered ), I have never seen or heard of this happening before here or on other vehicles.