Brake pads OEM Toyota or JURID

I have a 2016 Camry & made to 200K miles before I had to change the brake pads.

The brakes will give you signs of wear prior to needing to get them serviced or replaced. It also depends on how you drive. I’m at 81k on the original brakes right now and still have life left in them.

I have a 2021 Corolla and the stock pads are on 70k miles, I've never had a new car with the pads lasting this long. There is a a lot of material left and I'm definitely getting the exact OEMs for replacements.

OEM pads made it ~62K on my '17 OR with a lot of towing. Rotors didnt have any wear.

I used a Toyota corrola for work . Hybrid 3rd generation. IV done 250k miles and so far . No mechanical faults . Only faults have been brakes . That's another thing due to the regen braking you can expect 150 k miles from your pads . Your disks will likely rust before they wear

Pred 2 rokmi slo extra cca 200e na vyfuk a zadne brzdy a tento rok som menil komplet brzdy co vyslo 366e.

Brake pads - $90 for parts

Buy pads and the sensor from FCP Euro. Use their lifetime replacement warranty for the next set. Went to the dealer in July for an alignment and they recommended pads for a similar price. I bought pads rotors and sensors for front and back, total was $1000 for BMW parts. You could save with Jurid which is listed as OE and OEM. My pads are at 4mm all around so I'm actually waiting for the sensor to trip before doing the job.

The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.

This happened to my Gen2. I gave it to some guy to change pads and these lights came out after. I think he didn't do it properly and air entered into the line. I then took it to a local Toyota dealership where they fixed it. (I don't recall what they did exactly, maybe flush and replaced the break fluid). I was fearing it was the actuator, which as other have posted, is very expensive on this Prius. I had to drive very slow and careful, because I had no power in the brakes, so they were hard and slow. No ABS. No regen either.