Brake pads OEM Subaru or Bendix

After 217k on my 93 Eurovan I am still on my original rotors. I do change pads every 35-40k usually Bendix

oh and i replaced my craptastic wagner thermoquiet pads with bendix pads much better feeling on the pad and the calipers dont seem to get so hot

The STi also stops hard. It turned in the shorter braking distance of the two cars, using just 114.5 feet of asphalt to haul down from 60 mph. Pedal feel is firm and progressive, and ABS operation is quiet and refined.

Subarus in general are frickin' bulletproof. (WRX transmissions aside) I drove a Subaru Legacy 30th Anniversary Edition (2.5 liter, automatic...I think it's pretty similar to the '97 Legacy GT) and it was a surprisingly good drive...good handling and pretty good power...brakes were a bit sucky, though.

Bendix Titanium pads with new rotors 4/20/02

I put in some new rear brake pads today. The frist brakes I had were Autozone brand. Well, they went on fine on the driver side. On the passenger side It was near impossible to push the piston back far enough to get the pads on. I still needed about another 1/16th of an inch. I even bled brakes a little to make room for the piston compression. Still no luck. So I went back and bought some Bendix that were about 1/16th less in thickness. So, I put them on the passanger side. I had to wrestle with the piston again - that mofo would not budge. Finally I got it. So, I go for a drive with Albany brakes on one side and Bendix on the other. A horrible scaping erupts from the driver's side. The side that went on much easier. Visual inspection looked ok. So I took them off and they were all scraped to heck. Strange, as that was the easy side. So, I put the Bendix pads on that side and everything is fine.

IMHO, the brakes are also awful.