Brake pads OEM Mazda or WILWOOD

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

I was quoted 1200 to change my brake pads on my ND. Did it myself of course but it was funny to find out what the dealership wanted.

Took the car in for a service , got a work car and it's been driving the Rx much less. I wouldn't have done it all at once, so did a service, replaced brake pads.

I got my 2015 M3 2.5, 3 years ago with 30k Miles, now at 150k miles I have gone thru a lot of maintenance items. Additionally, my 15’ M3 GTS is “Made in Japan” not in Mexico, (some parts are actually different, Like my brake pads!) I attribute this to having a better built car.

So far I've spent 400€ on brakes, 100€ new battery, 1200€ on axles and other components related to them and maybe 150€ on oil and filters (2 oil changes so far)

Back in March I got fed up with the B5 platform shenanigans and started shopping for a Subaru... Upon entering the Mazda dealer, I got the typical \"We don't have the exact one you want in manual, but we do have this...\" and I decided to humor the salesman. Lo and behold, a 2012 Mazdaspeed 3 appeared before me... With 263 ponies and 280 ft/pounds of I could dead, the MS3 has proven itself to be the best possible car that a 23 year old male could own.

I have run Wilwoods on my Corrado for years with the usual rebuilding every two years. Even with ABS under full braking using the BP10 pads it would occasionally lock up fully and blow a cogged belt off the supercharger.

I don't know much about Stop-Tech, however, I have heard from a friend that used Wilwood that these perform best in non-Winter driving conditions. He said that over time they will not stand up as well as a Brembo set up. It might be worth noting what climate (Alaska vs California) that you spend most of your driving time in as well when factoring a BBK upgrade. I also noticed that you are quite new to this group so allow me to introduce you to the member who will derail all original posts into something else to the point where your thread may get locked up. See below. GoGo Golf R said: Ok let's try to agree on the following: 1) Upgrading the brakes is mostly justified for track driving purposes No, Personal preference. 2) Changing the brake pads will reduce dust for street driving Depends on your pad choice 3) Changing the brake pads, rotors and brake lines is pricy Subjective 4) The OEM brakes, while not totally ideal for every driving style, will suffice for average street drivers and some track drivers Depends on your driving style 5) Downshifting with correct rev-matching, will extend the duration and reduce wear on the brakes Yes because replacing your clutch is much cheaper than new pads :screwy:

Just had a dealer give me an estimate of $560 for new rear pads and rotors. Unfortunately, the idiot was going by mileage and he never actually looked to see that I just replaced the pads and rotors myself 10,000 miles ago. That was on my 2016 Mazda CX 5.

The brakes - overheated on several occassions coming down mountain passes. This happened on 2 sets of brakes so it seems like a design issue.