Brake pads OEM Mazda or GALFER

Galfer pads and rotors. I'm 210lb and can confidently slow down with rival flat mounts and 160mm rotors

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

Galfer pro pads are the best ones I have ever used. They have more power, maybe same amount of modulation as shimano ones, they seem to resist fade better amd have ok life span.

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

I was quoted 1200 to change my brake pads on my ND. Did it myself of course but it was funny to find out what the dealership wanted.

Took the car in for a service , got a work car and it's been driving the Rx much less. I wouldn't have done it all at once, so did a service, replaced brake pads.

My cx9 was at 3mm on the rears at 52k. Get a caliper compression kit and it yourself. It's not very hard. I did my rears a month back in my driveway for $130.

Seems a bit sus - but it's not unusual for rear pads to wear faster than front on certain cars. My Ford Flex and CX-50 both wear pads faster out back (it made sense on the Flex because of long wheelbase but was surprised the 50 did it too). That said they should last twice as long.

Just had a dealer give me an estimate of $560 for new rear pads and rotors. Unfortunately, the idiot was going by mileage and he never actually looked to see that I just replaced the pads and rotors myself 10,000 miles ago. That was on my 2016 Mazda CX 5.

I just switched from OEM (Brembo HH Sintered, I think) pads to Galfer HH Sintered pads. I forgot to scotchbrite the discs and I think I glazed everything up during bedding-in process. I used scotchbrite like mad on the discs and sanded the pads with 220 grit until they were dull like when new, but the brakes seem to have the same behavior - heavy brakes test after 10 mile bed-in ride, the brakes plateau without getting to ABS trigger unless I squeeze like a motherfucker. The previous pads I could stand up on the front wheel with one or two fingers, so I feel like I've done something wrong.