Brake pads OEM FORD or Hawk Performance

I run HP+ now on the jetta and they scream when cold, I could care less, they stop really well when you need it.

I have Powerslot Rotors. Hawk HP+ pads. SS brk lines.

Actually pretty good. Smooth step in, but really bite if pressed hard. I do have much more pedal now with the rears swapped out. I was suprised how thin they were!

I upgraded, I got the Hawk EPS pads from Tire Rack, (see the top photo). I have the Hawk EPS front and rear.

Instead I rebuilt my original calipers with a rebuilt kit from AutoHausAZ, bought a set of Hawk HPS brake pads, ECS stainless steel vinyl-wrapped brake lines all around, and Brembo cross-drilled and slotted rotors times four. Finally I used ATE synthetic blue brake fluid and a power bleeder, which I highly recommend for our cars.

If you'd like to correct the brake balance, put some higher cF pads on the front axle only. Hawk HPS works well. Leave the rear with OEM pads. Seems counterintuitive, but this will prolong the life of the rear pads and reduce ABS activation on hard stops.

Look at getting Ferodo DS2500 pads on the front axle and Hawk HPS pads for the rear axle. This is a HUGE upgrade and will improve your braking performance tremendously for both street and track.

I just had my brakes done all around, ATE rotors with Hawk HPS pads FTW, very little brake dust and my isht stops on a dime. I had my fluid flushed too, this upgrade was def worth the money

I had a track day yesterday and I think my rear brakes are overheating. The rears are 9.1" solid rotors with Hawk HPS pads. The edge of the pads close to the rotors turned an orangy-brown colour and smelled real bad after my last session. I'm pretty sure it is overheating.

I didnt like the HAWKS AT ALL.