No, no scan tool is needed at all for the fronts. They are basically the same as any other brake job. I actually found them easier than my other vehicles
I’m on 108000kms in my 2017 GLI and it runs like the day I bought it. I do the maintenance on time when needed and it is trouble free. So far all I’ve had to do is the brakes.
Since we had good luck with OE, went OE for replacements. So far, a few hundred miles in, all good.
I've done an almost complete overhaul on my bought-from-OG-owner low-k '07 B6 3.6 wagon. DSG from an R36, completely rebuilt suspension front to back on airbags, brakes, wrap, interior, sound system (the list goes on and on) for less than the purchase price of a used-by-who R36.
Have original brakes on it at 66000 miles.
Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.
The only other good thing from this visit is that they measured the brake pad thickness which confirmed that I need to replace the pads soon. We are currently at 59k and the rears are in the red at 3mm while the front was at 5mm.
OEM VW brakes are crap.
Same on my wife's '22 Atlas. So much so that I think it activates the parking sensors on every occasion when we slowly come to a stop, like in a red light and nothing is around the vehicle to make the parking sensors activate. It's just at 37k miles but I'm considering upgrading the pads and rotors!
I had to replace my brakes early as well, and I was also past the extended warranty campaign.
Write your review
Help others - share your experience with this part.
