Brake pads JURID or OEM Mazda

I inherited a 2011 cx7 from my parents who purchased this car new. They have always kept care of their vehicles. This is a non turbo model. Other than normal maintenance items they had replaced the AC compressor. Since I took it over in 2020, I replaced drive side front wheel bearing and passenger front caliper, brake pads all the way around plus normal maintenance items. 320,000km runs perfectly.

2016.5 CX-5 with 89,000 miles. So far I've had to replace the belt tensioner, accessories belt, water pump belt and breaks (technically I only needed pads and front rotors but I chose to just do them all in one shot since it made a negligible price difference since I was already doing the back pads.

Brakes - about to get them changed for the first time.

At 55,XXX miles and still haven’t changed my brakes on 2019 AWD Mazda 3(not as heavy as yours but heavier than a FWD 3) Last service, I was in the green for both sets still, but they said I would likely be in “yellow” by 60-65k. I did want to note—I hear no scraping/squealing and brakes feel relatively strong just not as great as new.

2015 sedan. I did my brakes last spring. I went with OEM as I found them cheaper than any aftermarket I could find near me and as far as I knew I still had OEM on my car and had lasted me a long time. Zero issues since having them installed, I’m happy.

I was quoted 1200 to change my brake pads on my ND. Did it myself of course but it was funny to find out what the dealership wanted.

The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.

oem brake pads are ceramic (low noise, low dust, minimal rotor wear, less bite)

Just had a dealer give me an estimate of $560 for new rear pads and rotors. Unfortunately, the idiot was going by mileage and he never actually looked to see that I just replaced the pads and rotors myself 10,000 miles ago. That was on my 2016 Mazda CX 5.

In hindsight, however, I do drive 15 miles up/down/through a mountain pass 5 days a week. That’s gotta be the culprit!