Brake pads Hella Pagid or OEM Chevrolet

I fitted a Pagid discs and pads (fronts and rears) to my Octavia vRS a couple of months back and don't notice any difference from the previous OEM. Paid £230 just for the parts.

Almost never, this is a picture of my front driver brake pads after 80,000mi. They are above 90% 2017 Bolt.

Put 306k miles in 13 years, on my brand new '07 Silverado 1/2 Ton before I sold it to a mechanic at my preferred shop (leak in the fuel system/tank that was going to require removing the bed etc).\n\nPrior to that issue, I never had a single thing go wrong with it. Tires, brake pads (original set lasted 200k miles), oil/tranny fluid changes, air filters, wiper blades, were all it ever needed.

I'm running the cheapest coated rotors from rockauto and Pagid "OE" pads and I'm happy with it.

I use Pagid RSL29s on my M3, I don't bother switching pads after events. They work great on the street but I'm in Texas so it rarely gets below 45 degrees here. They squeal but the dust isn't too bad. I don't daily it but I wouldn't have an issue if I did. The squeal is annoying but really not too bothersome to me even though I drive 95% of the time with my windows down.

I've been researching brake pads recently since I was looking for something to replace my awful Akebono pads up front. What I've learned is that Textar and Pagid are OEM pads and will have the "BMW brake feel". Textars are usually on the rears and Pagid on the fronts. Bosch is supposedly not quite as good as the other two. I bought the Pagid pads and man, what an improvement from the Akebono. I can stop again without having to jam on the brakes.

You will need brake cooling/ducts or will need to remove the dust shield to get more airflow (or both), went through a brand new set of rear Pagid RS29 endurance pads in less than a weekend in July when I first got the first F80 years ago. The heat did a number on them in the afternoons with ambient temps over 90 and all the 150ish to 40ish and 130ish to 30ish on the back and front straights respectively

I had to replace my Bolt's pads because of using the friction brakes so little due to one-pedal driving, they rusted out. It's actually important to make a point of using your friction brakes every now and then.

I have about 1k miles on my 25 Equinox EV and the brakes have started doing this. It’s horrendous backing out of my driveway and at drive thru’s. Sounds like I’m driving an old beat up car that I haven’t maintained.

Back in September 2024, I bought two Chevy Equinox EV 2025s — one for me and one for my wife. Both vehicles have less than 10,000 miles on them. And guess what? Both are already having the exact same issue: the brakes make a horrible squealing noise every time you press the pedal, and when you go in reverse the sound is absolutely unbearable.

I’ve taken both SUVs to the dealer twice already. Each time I had to pay $35 for a brake inspection, and both times they told me “everything was fine.” Now, on the third visit, they suddenly tell me the brake pads need to be replaced, and it’s going to cost $498 PER VEHICLE. That’s nearly $1,000 out of my pocket for what I strongly believe is a manufacturing defect.

Here’s what frustrates me the most:

• Both vehicles are covered under the extended warranty, but the dealer says brakes are “not included.”

• They claim the warranty only covers the battery and motors.

• How is it possible that two brand-new vehicles, same model, same mileage, bought at the same time, have the same brake problem, and it’s NOT considered a factory defect?

This makes zero sense. Honestly, I feel scammed. I trusted Chevy, bought two brand-new EVs, and in less than a year they’re already trying to squeeze almost a grand out of me for something that should not be happening.