Brake pads EBC or Hella Pagid

On the 63S I spend 150 each Brembo rotor and 180$ EBC redstuff pads, hardware 10$, sensor 8$. These things are silly easy to do on the rear.

I have Speigler stainless lines, EBC pads, and Motion 5.1 fluid in mine.

Get the EBC RedStuff kit from FCP. I've had them on several cars and it's exactly what you describe. They held up to some AutoCross as well.

DBA 4000 T3 high-carbon rotors and EBC Red Stuff pads improved modulation for me significantly.

EBC Redstuff for the street, low dust keeps the wheels looking nice.

I got mine February this year, M5 F90, Pre-LCI (2019), just about 40k miles; Lovely car and I have been daily it. Just like other have said, get one that has been looked after and serviced. For me, it was an approved used and was just serviced before collecting it, it had new brake pads and discs, the OEM pads are awful and replaced them with EBC Yellow stuff brake pads, I would recommend if you ever need to replace pads.

As an EBC Red owner myself. These pads are not built for abuse. Like at all. They're a sporty street pad at best.

I’ve got EBC blue stuff on my Chrysler 300 (weights like 4400lbs) with EBC slotted rotors. The factory pads were quite easy to overheat to where you can feel a decrease in braking performance, by the time I installed the EBC pads, the factory pads and rotors pulsated. With the EBC blue stuff pads I have yet to feel them fade (no track use). Some downsides, they dust like crazy, my chrome wheels are a dull gray in just a few days. Additionally they sometimes squeak and squeal, they also feel a little worse than factory pads for initial bite when it’s really cold out such as 20f. Lastly they aren’t supposed to last all that long.

I am on their RP-1 pads but I get terrible vibrations after they get heated. I suspect its because I didnt change rotors from my previous pads. I just thought they'd be rebedded after a few hard stops with the new pads.

Only pad I've had torque change on was EBC yellow, once it gets close to backing plate the brake torque drops off a cliff, I suspect it's the adhesive they used