Brake pads EBC or Hella Pagid

I run Pagid Street+ pads with DBA rotors. I like them

I use EBC YellowStuff. They are great on the street and very predictable & consistent at the track. My local track is not very brake intensive: I’ve run 8 track days on the same set of pads plus lots of street miles in between. They’re due to be changed before my next track day.

EBC Bluestuff NDX Appears to perform similar to DTC-30/ME20 or equivalent as a hybrid street/track pad. I know a couple fast drivers that use them with no fade. They're cheap enough that you might as well give them a shot, make sure "NDX" is in the product id.

Redstuff pads; excellent bite, zero dust

Pagid every time. Never had a problem with any car I’ve put them on.

Back in December, I had discs and pads replaced all around on my 2018 Octy vRS. My local garage was happy to fit supplied parts. With the discount Halfords were running at the time, I've had Pagid discs/pads fitted. No rattles, no squeaks, and they stop me when they need to.

If you want more braking performance but don't mind the extra dust, the EBC Yellowstuff pads are my favorite street pad.

Have had EBC Red stuff, Yellow stuff and Blue stuff. My impressions of them are below:

Red stuff - slightly better initial bite than an OEM pad, the same goes for performance at higher temps, however on track they didn’t last more than a couple of laps. Certainly more of a daily/fast road pad.

Yellow stuff - initial bite ever so slightly lesser than the red stuff, probably inline with OEM. However they put up with more abuse at higher temps and rarely gave much brake fade. Bit dustier, would say fast road/occasional track pad.

Blue stuff - initial bite worse than OEM, after a few hard stomps you can feel them waking up. Stand up to track abuse very well. After multiple fast laps on track, I felt it was the discs that were getting too hot, so these pads highlighted I needed brake cooling to keep going. Squeak at low speeds, dusty.

To answer your question, imo there isn’t a situation where blues are more ‘streetable’ than reds, I’d swap them out for reds and if you can, keep blues for the track ????

HTH

I legit just installed the same pads and rotors and the squealing is driving me nuts. It’s only from my passenger side and happens sporadically under light breaking. Everything I have read says it will go away. However I’m at about 400km and it’s still there.

I got about 500 miles on new EBC red pads and EBC rotors. They made so much noise when I first installed them, now only the driver side is still making a squeal on occasion. I assume the passenger side bedded and the driver side is close behind. My main question is for anyone who has these pads, do they ever chill out on brake dust? I can only assume they are not fully bedded in yet but holy god they dust like crazy. I can honestly say this whole experience has been terrible and EBC customer service is non-existent.