Brake pads Centric or OEM Volkswagen

I did our Atlas rear brakes without a scan tool.

I have done the all the brakes on our 19 Atlas myself. Like previously stated fronts are straight forward and easy.

No, no scan tool is needed at all for the fronts. They are basically the same as any other brake job. I actually found them easier than my other vehicles

I’m on 108000kms in my 2017 GLI and it runs like the day I bought it. I do the maintenance on time when needed and it is trouble free. So far all I’ve had to do is the brakes.

Since we had good luck with OE, went OE for replacements. So far, a few hundred miles in, all good.

I’ve always done centric. Good quality, good performance and good price

If you're looking for a solid set at a budget price, I've always had solid results from Centric and Power Stop brands on Rockauto. They're not high end by any means but they're cheaper than going OEM and they've always lasted at least 40,000+ miles. Also, if you go to Rockauto, do not be tempted by their economy category. The offerings in that section are very inexpensive but you absolutely get what you pay for. I went that route once out curiosity and the pads and rotors from the economy section were awful. Squealed and squeaked from day one and wore down insanely fast. Tried sound dampening sprays and re greasing. Never took the noise away.

I'm kind of disappointed with the factory VW pads that came with my 2019. My 2013 ran for 120K before the brakes needed replacement. Also, these pads leave a lot of brake dust on the side of the car.

The only thing wrong with them are they are too soft, organic pads. Switch to a metallic pad.

Secondly, defective Rear Disk Brake Pads that wore out on a majority of 22` Taos which was a covered rear Brake replacement if it was under 2ydears and 24 months. I just missed the cut-off and was$700 poorer.