Brake pads Carbotech or Mintex

Been running carbotechs on my m2comp and C's and 2 seasons. Love them. Xp10 up front, xp8 for the rear. Track only pads that I can drive to the track with

I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.

I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps

XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this

I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.

carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.

I've got mintex in mine at the moment and they're not too bad, they weren't very expensive but they seem to do the job

I run carbotech xp8 on the front of my c5. Still a group 2 level driver. They’re a good pad for a car that’s driven to the track and home, but dirty and noisy at times for a street pad. They’re considered entry level track pads. I chew up rotors but don’t get fade, but my local tracks aren’t particularly hard on brakes

I used Mintex red's on the 54's - once, a while ago - and I was not impressed.

when i bought my girling 60 setup the seller threw in a set of mintex red box pads.....i hate them. i was never impressed with the red box's in other cars but on my setup they squealed like crazy when i was off the brakes. i too had the issue with the pads overhanging into the center of the rotor but i took a rolox disc on a die grinder and took a little off the inner portion of the pads. even after doing that they still squeal. plus theyre a real dirty pad and after about 10k miles i only have about 50% pad life left.