Brake pads Carbotech or GALFER

I am currently using Carbotech XP10's in front and the XP8's for the rears. I really like them and have not had an issue so far. Plus the company has great customer service. They are definitely NOT a street pad, and I need to swap them the night before a track meet and put street pads on the day after, but the effort is worth it.

I just replaced my pads all around with Carbotech so i get majorly reduced brake dust and just OEM rotors.

If you KNOW you're going to be doing a lot of track days, you definitely want to go straight to some full blown track pads, at least for when you're at the track, along with fluid.

With the XP8s I had, I left early and bed my pads in on the way to the track.

Running Carbotech XP8 and XP10 here. They’re great on track, and also very usable on the street. I’m currently not switching back to my EBC Yellowstuff pads because the Carbotechs aren’t bad enough on the street to justify me switching pads (yes I’m a being a little lazy). They dust like mad though and are quite squeaky.

The xp12s are beasts. I pulled brake bias 1-click from full rear to get them balanced on level braking. This gives me one click for more rear, which was really enough for the track. I love late braking, and I can hammer these on a 20min session with NO change in performance.

I sometimes daily drive on Carbotech XP10 front XP8 rear, and they’re totally fine but they dust and squeak like mad. First braking when cold isn’t super grabby but totally doable for a daily driver pad. They’re grabby once warmed up on the street but nothing to be worried about. I’ve gotten ~10,000 miles of driving and two TNIA track nights on a 450hp 3500lb car, and i suspect they can last a lot longer than that based on the pad wear I’m seeing.

Just for daily, whatever the best Duralast pads AutoZone had to offer with some centric blanks. For the mountains, I run Carbotech AX6 on DBA rotors and love the performance they offer. They just dust like hell and their expensive, so I don't run them back home.

Over 25 track days I tried : RBF600 + stock pads -> Failed

RBF600 + powerstop -> Failed

Endless + Carbotech xp12 -> Great but wore off quick

Endless + CSG -> less bite but much more durable

I just switched from OEM (Brembo HH Sintered, I think) pads to Galfer HH Sintered pads. I forgot to scotchbrite the discs and I think I glazed everything up during bedding-in process. I used scotchbrite like mad on the discs and sanded the pads with 220 grit until they were dull like when new, but the brakes seem to have the same behavior - heavy brakes test after 10 mile bed-in ride, the brakes plateau without getting to ABS trigger unless I squeeze like a motherfucker. The previous pads I could stand up on the front wheel with one or two fingers, so I feel like I've done something wrong.