Brake pads Brembo or JURID

I just put some Brembro low met pads on out SQ5. They are more progressive bite, but I like them better than the Hawk HPS 5.0 on my S4. When you get on them they stop very well. Not sure on dust yet.

I recently installed Brembo pads. It cost around £150 for the whole set (1 pair at the back, 2 pairs for the front). But the new ones are day and night difference. It's now super sharp with amazing modulation.

Brembo pads are better than oem and cheaper through rock auto. Recommend oem rotors though.

We use (and sell / stock) the Brembo rotors and sport (HP2000) pads. Better performance than stock, perfectly streetable and equally capable for track days or tarmac rally. Great value too

I had EBCs on my 2010 for about 40k miles and liked them. Switched to brembos 2 weeks ago and they aren’t as good. They’ll last longer though I’m sure with less dust. I wouldn’t say it’s overkill, it’s a big vehicle and you can’t put a premium on stopping faster especially if you do any towing.

I replaced the front rotors and pads with factory Brembo at 45k. When the rears needed replacement at 55k, I replaced the front and rear rotors and pads with PowerStop Z26. Couldn’t be happier with the swap - less dust and better stopping than stock.

Just replace the rears with the same brake pads aftermarket really suck. They do wear out fast but their worth it. Rotors get them Online their about $250 for two rear rotors and brake pads runs around $300 for the Euro pads for the Dynamic Edition.

OE benz brakes have small depressions drilled in to the face of the rotors. When those disappear, you need new brakes. If you see dimples, go on to the next square...I have a 2019 C43. Second set of pads front, Second set rear, 106k miles. My wear indicators are almost gone, so I have a set of OE brembo rotors and Benz pads sitting on the shelf. I am waiting for the dashboard warning light...front and rear have a sensor that will alert you when you are almost done.

The pads were about 60% worn and hard large metal shards embedded in them and the rotors have always been badly grooved from day 1. This suggest that its more likely the rotor that is a soft material. Once there are metal shards in the pads that will cause uneven friction and promote brake grab and pulsing. I replaced the pads and the \u201cwarp\u201d pulsing has gone completely, but I suspect the new pads will also eventually pick up metal shards from the rotor. The other point is in case people want to avoid factory pads is that the front pads are Jurid and the rears ATE. I ve replaced all with Padid.

My brakes are starting to squeak so I contacted my local Subaru dealership to get quoted on my front brakes as the rear are still in good condition. They quoted me for $1200 to replace the brembo pads and rotors as they insisted that drilled rotors need to be replaced EVERY TIME you change the brake pads as they cannot be resurfaced.