Brake pads Bosch or WILWOOD

Brembo, bosh and a few others mentioned in another comment are all really good too.

I got the Bosche pads. I think they were in a higher category than daily but the front+back together ended up being cheaper then other brands I was looking at. Just make sure you get ones clearly labeled front or back, and Japan built.

I got BREMBO rotors and Bosch quiet cast pads, happy with the purchase.

I was very happy with Bosch BP621 brake pads. It had excellent grip.

Look on rockauto, and look for the brand called bosch, they kick ass and are oem quality

I went with Raybestos rotors and Bosch QuietCast pads. Equal if not better than OEM and much much cheaper.

So I followed their direction and jumped on the old interwebs to my retailer of choice, RockAuto, and ordered Bosch pads and rotors front and back. So I had nothing planned for the weekend figured I would do a little wrenching. Take the wheels off and start to unbolt the caliper, looked down and my rear pads still show about half life. Maybe they just meant the fronts, pop the wheel and they are showing even less wear. My question is it normal for the CX-5 to go 80000 miles on the original pads? I didn't think I drove like my grandmother but it is 70% highway/non city driving. For anyone that does your own maintenance the cost for 4 rotors and pads was less than $200 (Raybestos Element 3 rotors and Bosch Quiet Cast ceramic pads). It really a fairly easy job, and would not take more than 30 minutes per wheel.

Bosch quiet cast

I went for Bosch models. Fronts have faired much better than oem. Rears I had some other issues (didn’t use service mode) that destroyed them prematurely

For my (owned 3 years, purchased used) 2014 Honda Crosstour I've always had to grind down the edges of the pad mounting plate tabs on Bosch brakes a couple of mm to get it to fit into the calipers. I have just received a new set, and while I still had to grind down the edges to get them to slide into the calipers, the top and bottom edges were MUCH shorter than the previous pads. So much so that when braking after reversing direction, the pads will shift in the calipers with a noticeable 'click' as the brake pads engage the disks to slow the car and are thus moved to the other end of the caliper. The overlap between the brake pad plate and the 'C' in the caliper where the tab meets the caliper is only 2mm or so. Definitely less than I am comfortable with.