Brake pads Bosch or WAGNER

I got the Bosche pads. I think they were in a higher category than daily but the front+back together ended up being cheaper then other brands I was looking at. Just make sure you get ones clearly labeled front or back, and Japan built.

I got BREMBO rotors and Bosch quiet cast pads, happy with the purchase.

I was very happy with Bosch BP621 brake pads. It had excellent grip.

Second upgrade to Wagner Thermo quiet brake pads and rotors.

Look on rockauto, and look for the brand called bosch, they kick ass and are oem quality

I just changed my rear breaks and rotors on my 2018 limited and will be doing the fronts next week, I have always used Wagner Breaks and rotors. I have been using them for 20 years and 5 of those vehicles have been jeeps with zero complaints.

Wagner OEX. It's built on a galvanized steel backing plate so it doesn't rust like the painted ones. It also uses a mechanical attachment system to hold the friction material instead of glue, so it won't crack/detach like the cheap pads.

I went with Raybestos rotors and Bosch QuietCast pads. Equal if not better than OEM and much much cheaper.

Just a word of caution, I ordered Bosch pads off of RockAuto and received off brand pads wrapped in shop towels in Bosch boxes. Still put them on and they're alright, but not what I bought. Wasn't worth it to me to send back. Not RockAuto's fault, they have third party suppliers. I'm sure they would have taken care of it had I cared enough

For my (owned 3 years, purchased used) 2014 Honda Crosstour I've always had to grind down the edges of the pad mounting plate tabs on Bosch brakes a couple of mm to get it to fit into the calipers. I have just received a new set, and while I still had to grind down the edges to get them to slide into the calipers, the top and bottom edges were MUCH shorter than the previous pads. So much so that when braking after reversing direction, the pads will shift in the calipers with a noticeable 'click' as the brake pads engage the disks to slow the car and are thus moved to the other end of the caliper. The overlap between the brake pad plate and the 'C' in the caliper where the tab meets the caliper is only 2mm or so. Definitely less than I am comfortable with.