Brake pads Bosch or Project Mu

The anodized drilled/slotted rotors just got their 2nd pad change with Bosch quietcast ceramic pads. Zero noise,much less brake dust and last longer than the 2 years of the messy oe pads on our 3.7 ton Yukon.

The best solution I have found is to use slotted rotors--cryo treatment typically gets me 10K more miles before hard spots develop and I get a pedal vibration--and an aggressive pad without any ceramics. My solution is to use the best quality slotted rotor I can find, cryo treatment preferred, and use either a Wilwood BP-10/20 pad or a Project Mu NS brake pad. I found those two pads were aggressive enough to have great stopping power and would wear out the rotor at the same rate the pad wore down.

I personally use Project Mu HC+800 for their fantastic cold bite and high temp resistance.

Just bought some Bosch brake pads and rotors off of Amazon. Made in China as well. The quality of the products were good too. Fit perfectly and works very well.

I use Bosch QuietCast brake pads. Never had a problem and work great.

So today I put on a new pair of Bosch brake pads, flushed the brake fluid, and removed that sensor from the windshield washer reservoir. It was too easy.

I used Bosch pads and rotors when I last changed my front pads [available from Amazon.com]. 13K on the new setup with no problems - stops well, quiet, no vibrations - and the non-friction surfaces of the rotor aren't rusty.

i just put on new pads and rotors, front and rear...i bought Bosch Quiet cast and 100 miles in i like them. Shims are molded to the pad and no noise at all. Stop a little better than what ever i had on there before.

I formerly owned a 1988 300E and sold it with 150,000 miles. This vehicle was incredible and changed the way that I look at automobiles forever. I honestly believe that the 124 chassis Mercedes-Benz was one of the very best cars ever built. The rear brakes would simply scream if you used anything other than original brake pads.