Brake pads Bosch or OEM Honda

I use Bosch ceramics on mine and they're amazing.

I went with Bosch QuietCast rotors and pads . The Akebono pads performed well, but wore out faster than I'd expected. I don't know if the low wear on them caused scoring of the rotors or if it was the calipers not doing a proper job... but I did not detect a loss in brake performance, which was really strange. This was happening to the rear, so maybe the front end brake system was compensating.

Also my rear brakes say Bosch on the center of the pad so mine could be different from yours if yours aren’t showing the brand.

The anodized drilled/slotted rotors just got their 2nd pad change with Bosch quietcast ceramic pads. Zero noise,much less brake dust and last longer than the 2 years of the messy oe pads on our 3.7 ton Yukon.

2000 Honda Oddyssey

High mileage but runs good, small dent on driver's quarter panel. Rebuilt trans, shifts good, engine runs great just had valves done. A/C doesn;'t work probaly needs freon. 3.5l v6 automatic. Aftermarket radio HAS AUX JACK. New headlight lenses, new intake tube, new break pads

Just bought some Bosch brake pads and rotors off of Amazon. Made in China as well. The quality of the products were good too. Fit perfectly and works very well.

I use Bosch QuietCast brake pads. Never had a problem and work great.

So today I put on a new pair of Bosch brake pads, flushed the brake fluid, and removed that sensor from the windshield washer reservoir. It was too easy.

I used Bosch pads and rotors when I last changed my front pads [available from Amazon.com]. 13K on the new setup with no problems - stops well, quiet, no vibrations - and the non-friction surfaces of the rotor aren't rusty.

My buddy's Honda ELF seized a caliper on the way down a mountain. By the time we found a place to pull over, the pad material had caught fire. That was exciting.