Brake pads Bosch or OEM Chevrolet

I also have those Bosch pads on my Tundra and they are really good, quiet, low dust, excellent overall.

I think the Bosch pads work fine.

Last year a shop replaced the rear brake pads and disks but since then handbrake never was like before. They kept telling me it will get better which I believed at the time but it never did. Last month I've passed inspection and they told me that the rear left handbrake was almost out of spec and I'd need to check it out although it passed.

So a month later I've bought a Bosch kit, sliders, pads, grease, toolkit etc and replaced the 1 year old ferodo pads. Now handbrake is like it should be and I'm happy with it but take a look at the old pads...

Both inner side alignment pins (caliper side) are bent.

Last month I've passed inspection and they told me that the rear left handbrake was almost out of spec and I'd need to check it out although it passed. So a month later I've bought a Bosch kit, sliders, pads, grease, toolkit etc and replaced the 1 year old ferodo pads. Now handbrake is like it should be and I'm happy with it but take a look at the old pads...Both inner side alignment pins (caliper side) are bent.

Bosch quiet cast or Zimmerman. Also Bosch blue pads, ceramic if you want clean and semi metallic if you want to stop

bosch quiet cast pads and rotors. changed my life

I purchased some DBA Sport Rotors from Australia which came with, I'm pretty sure Bosch brake pads which were brilliant!

Changed my front pads on 2021 Silverado and had same issue. Dash lit up with warnings and checking engine light. Disconnected battery for 30 plus minutes, pressed brake pedal 2/3rd way down and held for 45 seconds and released slowly, waited 15 seconds and repeated. Did this process for the entire 30 minutes. Reconnected negative terminal on battery and that cleared all warnings except check engine light. Drove for short distance and engine light went off. Just can’t reset my brake pad wear setting, so thinking new sensor may be bad so I ordered a OEM replacement.

Every time I get Bosch brake pads I\u2019m disappointed.

I had this problem after working on a friend's Infiniti FX35 and also using Bosch ceramic brake pads.

The problem for me was that Bosch pads have a different inside and outside pad for the rears for that vehicle. I've used Bosch pads before and never encountered this.

The pads were not marked and nothing on the box indicated there were different sides so I didn't notice. But they have protruding nubs on the backing that cause the caliper to not sit properly and increase their thickness, causing constant drag on the rotors.