Brake pads Akebono or OEM FORD

I love love love the Akebono ceramic pads for daily drivers. Little fading. Low (almost no) dust which keeps the wheels nice and clean.

Akebono pads if they make them for your application.

They are quiet and can tolerate cheaper chinese steel rotors.

I used Akebono pads and Zimmerman rotors. At first I didn't think they had the same bite as the OEM pads. After a few hundred miles they are good.

Akebono have been better for my 6 than the OEM. OEM pads are not all the same. They may meet the same minimum spec but not all are top tier. For example the rear brake pads on my 6 OEM were great and were made by TRW. the last set of OEM rear pads were from another manufacturer and are dusty and wear fast. My recent front OEM pads are the same. I'm going back to Akebono pads when the weather is better

Akebono proact brake pads paired with centric rotors. I like the centric premium rotors since they are painted on the edges and the hub mating surface. If those are too expensive then I'd go with centric c-tek rotors.

Akebono pads are usually excellent on hondas (I think they are oem?) As far as rotors, WBR and zimmerman are great. For an economy option you could try carquest pads/rotors. No matter which you go with, make sure to break them in properly because even the best pads/rotors will pulse if improperly broken in.

Running akebono here. Quiet, good for street use, and noticeably less dust compared to oem

Today I just installed Akebono ProACT (ceramic) in the rear. Very very happy with them. Stopping is still very good, they’re dead silent and dusting should be a ton less.

I had Akebono pads last time out with OEM and they were great. Low dust although they wore rather quickly.

I just put on Akebono ceramics and Zimmerman coated rotors and I hated them for the first few hundred miles. They took a very long time to break in, and this was after a) paying attention to the instructions that say no break-in is needed and b) ignoring that advice when the stopping distances were so bad initially that I bedded them in... and yet the pedal effort was so high that I could barely engage the ABS in the dry. So I'd recommend staying away from that combination.