Brake pads Akebono or DIXCEL

I've switched over to Akebono ceramic on all of my cars. They make so little dust it's kinda amazing. I would never trust them on a track day, but for daily or light spirited driving they're amazing.

I always recommend OEM pads, but the Toyota pads are going for $80 now for your Corolla. If you're on a tight budget, I'd go with Akebono for $57 at Rock Auto. Buying cheap brake pads isn't advisable.

Akebono Ceramic pads

I have used Akebonos on Jeeps, Toyotas, Ford's, Land rovers and now my BMW and honestly have never had a single issue. The biggest benefit is low break dust. They have always been noise free as well.

i have a 2014 Camry with 120k miles and my brake pads still have 50% life, you still have a bunch of mikes left to drive if you don’t brake aggressively. i would get akebono brake pads and oem rotors unless you plan on taking the car to the track

Neither, I installed the Zimmerman/Akebono kit this summer and am pleased with the performance.

Akebono pads are a bit pricey compared to some of the cheaper stuff you can get at your local autoparts store, but they are worth it if you just want your brakes to work well and be quiet. It's what Honda uses from the factory.

I would encourage you to pick up some basic tools, two jack stands , and a jack since you can save a lot of money down the road doing your own brake pads and rotors. Don’t cheap out on Brake pads and rotors since the very low quality rotors can warp very fast. I recommend getting akebono Brake pads and a decent set of rotors that’s mid range like centric. Brake pads are very easy to do and don’t forget to get blue threadlocker and to get a torque wrench and a breaker bar. As others have mentioned maybe in some auto parts stores in the Australia you might be about to rent certain tools. And there are tons of YT videos. Be sure to look for torque specs for your car. Also don’t forget to apply silicone brake grease to your caliper guide pins which is safe for rubber boots.

Dixcel ES pads are a “fast street” pad with low noise and dust that out perform oem pads and can be used for light track application also with effective heat range of 0-600 degrees Celsius. I think they’re the best “bang for buck” pad you can get.

On any modern BMW model those pads make the pedal noticeably softer, to the point where it almost feels like air in the lines. I've swapped many sets out due to clients being unhappy with the feel. Works fine on older ones though.