Brake discs STOPTECH or GiroDisc

I upgraded to stoptech drilled rotors with the posi quiet pads. I'm happy with the performance on street for spirited driving, and they create much less dust than my old Hawk HPS pads.

Reliability and safety are my main concerns right now, so I also have Girodisc rotors

I use stoptech cryo slotted rotors front and rear, stoptech stainless lines front and rear, and stoptech sport pads and I have been very happy. No squeaks, squeals, and very little dust. After my last track day they did go a little wonky on me but I took an afternoon to go get them a little hot again on a fun drive and they straightened out for me. No vibration/wonky wheel ever since. They have worn nicely and I had it all installed back on Aug 3, 2017.

Just put the same exact rotors on. With Hawk pads and SS brake lines too. Love it so far.

I threw that same combination on my genesis coupe to replace the brembos. This is probably a better brake set up and much cheaper, I beat the crap out of it on multiple track days with next to no fade.

Pagid is one of the industry leaders in brakes. They have other single piece cast rotors in the $100/ea range, just make sure you stick with something that uses a high carbon alloy. There's nothing wrong with going single piece, Stoptech's performance rotors are just drilled and slotted Centric high carbon single piece rotors. If you're going to keep the car long enough to realistically think you'll change the rotors again, then FCP Euro for the lifetime warranty. I've run Stoptech Sports and they're fantastic but make a fair amount of noise at the end of their life and expensive now.

I use stop tech on all my cars, kind of spongy at the very top but other than that they bite hard.

Almost every car in our PCA club runs GiroDiscs, even the GT and RS cars. Never heard a single complaint, and love them on my C2 and GT3.

Awesome! I used StopTech. Wanted slotted only, but they shipped me drilled and slotted. Oh and I went on doing the braided steel brake lines too for fun. So far so good ????

At ~4,000 miles, I bought a set of StopTech (front) drilled+slotted rotors (non-PP) for my GTI and kept my OEM brake pads. Everything was fine up until recently (~2,000 miles later). I now hear a high pitch "squealing" noise at very low speeds. This happens right when I'm about to come to a complete stop (1-3 mph).