Reviews of WAGNER parts For Business

I highly recommend Wagner OEX pads. Galvanized steel backing plates. Quiet. Long lasting

I purchased Durango rotors and Wagner brakes for my 2015 cx5 back in May 2018. According to my buddy my brakes were only 50%/35%(front/back/) done. I told him to change it anyways since he pulled them apart anyways. That was around 105k. Around Jan 2020, the rear brakes were squeaking. My buddy pulled them apart, and the rear brakes were completely done. The odometer was around 190k . I replaced them with centric rotors and power stop pads. The front was not changed as it looks like 70 left.

I’ve honestly never had a problem with Wagner. Just installed QuickStops on my wife’s Altima. They are quiet, and they bite just as hard as OEMs.

When I did my Civic, I went with Wagner Thermoquiets. But I'm not aggressive on the brakes. They're silent, and clean. They'll still cause ABS to engage if I hit the pedal hard.

I now use the Wagner pads the I can get through Advance. Last set went 60K and I just replaced them before the state inspection in October. Technically they would have passed but I just changed them out just so I didn't have to worry about it for a while. For $60 for an axle set, I can't complain. Cost way less, last much longer, easy on the rotors and don't dust the hell out of the wheels. They take a bit more brake pedal pressure but that is OK because it actually helps on brake modulation.

After much debate, I ended up going with the Wagner. Install was pretty easy and it feels very good on the car. The stock IC was def. choking the car with the increased boost. Temps seem more consistent after back to back runs, although not as close to ambient as I had anticipated they would be.

I just put a set of Wagner on the rear of my E60. Same pad specs and a perfect fit. The car stops dead fast.

I personally use Wagner Thermoquiet for my BMW because of low dust and noise-free. They are great pads.

According to Rockauto, Wagner ThermoQuiet parts are available for that car. I would just get those - I've used them on everything I've owned for the past 10 years or so with good results.

Ok, so, at a particular location I worked at we used Wagner Thermoquiets. Decent pads, but this particular location seemed to get the worst quality pads ever. The only way we could keep the customer from coming back was to make sure everything was well lubricated, and we also used some sort of orange goop to stick the brake pads to the calipers. Then we took it out for a break-in session, I believe it was 5 stops from 30mph, gently using the brakes, then another 5 with moderate brake pressure. And if the customer was too hard on the brakes it might still come back.