Reviews of NGK parts For Business

I put in NGK PFR7B plugs and R8 coil packs. Smoothed the idle out and judging by the butt dyno the rev/boost response seems great.

I run stock NGK with .026 gap as well and I've been anywhere from 10-18psi

The plugs were only part of the problem. (They were NGK VW/Audi part#1010000035AB, NGK BKB5EKU. Good plugs, lasted forever. Sure, they needed to be replaced, but the #6 plug well must have been flooded a time or two before the radiator was replaced last month. The metal plug jacket had a lot of green crud in it. I cleaned the plug jacket with cylinder brushes from Harbor Freight ($7.00 without coupon for an assortment 3 sizes in SS and brass) and finished with medium emery paper wrapped around a thin long screwdriver. The motor runs smoothly now, across the RPM range, without hesitation.. I'm wearing a pretty wide smile.

Oh and I missed on letter on the spark plug it's BKR6EOUP. It's a NGK "R" type.

I ended up swapping coils/ICM and put new correct plugs in, and now it runs waaaay better.

I have NGK double plat and they have been great. Over 10k miles. Just put some in my girlfriends 2.5 jetta as well with no issues.

Use the NGKs OP uses with factory gap. All stock apart from Stage1 Superchips tune now on 95RON. No issues 'cept consumption's falling now cooler temps are here (46\u00baF yesterday afternoon SE London) from 40+ on lightfoot long run to 36MPG same motorway run

ngk Same as prof315-jeff,bkr7eix on both setups,supercharger and now turbo and they still work,my only mishap is i bought a set bkr8 and one fouled do to much gas @ idle,now with megasquirt no problems so far.

NGK BKR7EIX is a popular plug for 1.8T and 2.0T, but it is one step colder in the heat range. Fine for those whom don't see freezing and below temps.

I'm having the exact same problems with my 01 GTi VR6, ive replaced the coil pack and wires/plugs twice within 20,000ish miles...